![]() Cement Technology
a division of Masonry Supply, Inc.
156 Piper Road
Covington, Georgia 30015
tel. 770-784-1424
fax. 770-784-0909
|
|
|
MixingA 50-lb pail of MS-CONCRETE RUB requires approximately two gallons of mixing water. For proper bonding, the mixing water should be blended with MS-ACRYLIC Bonding Agent at a ratio of one part MS-ACRYLIC Bonding Agent to three parts water. MS-CONCRETE RUB is then added to the mixing liquid. Mix to a slurry consistency by hand or use a slow speed (650 RPM) paddle mixer. Apply using a mason's brush or hard rubber float. After initial set, the surface should be rubbed to the desired finish using damp burlap. Safety PrecautionsThis product contains Portland cements. It is alkaline on contact with water. Use a paddle for mixing to avoid splashing into eyes or contact with skin. During mixing or application, avoid contact with eyes. In case of such contact, flood yes repeatedly with water and call physician. Wash thoroughly after handling and before smoking or eating. Do not take internally. WarrantyThis product conforms to current applicable specifications and is manufactured to meet published physical properties when properly cured and tested according to ASTM standards. Since seller has no control over the conditions of use or storage of the product sold, seller can not guarantee the results obtained through the use of its products. The buyer shall determine the suitability of the product for its own purpose. Seller shall in no event be liable for consequential (including loss of profits) or punitive damages. Seller's liability hereunder, if any, shall be limited to replacement of goods sold. This warranty is in lieu of any and all other warranties, expressed or implied.
|
Send mail to masupply@mindspring.com regarding this web site.
|